How to Install an LED Light Cornice
A light cornice hides an LED strip and directs the light onto the ceiling or wall. The result is soft indirect lighting that makes a room feel larger and cosier. Unlike an ordinary cornice, a light cornice also means thinking about the wiring and how the light will spread.
Plan the lighting first
- Have the electrical work done by an electrician. The LED strip needs a driver and a switch.
- At home, a 24 V LED strip gives a more even result. For living rooms and bedrooms, choose a warm white of around 2700 or 3000 K.
- Put the driver somewhere you can reach it later.
- The gap between the ceiling and the top edge of the cornice determines how far the light spreads across the ceiling. Before gluing, fix the LED strip into the cornice temporarily, hold the cornice against the wall and check the effect in the dark. It's the easiest way to find the right height.
Why you need aluminium tape
Before fitting, apply Mardom aluminium tape to the inside of the cornice where the LED strip will sit. The tape does three jobs.
- It stops light shining through. The polymer lets a little bright light through. Without tape, light patches and joint lines can show on the front of the cornice.
- It reflects the light where you want it. The aluminium bounces the light up onto the ceiling, so the band of light is brighter and more even.
- It helps the LED strip last longer. Aluminium draws heat away from the strip, and the strip sticks better to a smooth surface.
If you can see the individual LEDs as dots, use an aluminium profile with an opal diffuser.
Tools
Cut the corners with a mitre saw and a fine-tooth blade made for plastics and laminate. The right blade is the key to success, because in a light cornice the light shows up even the smallest gap. You won't get that kind of accuracy with a wooden mitre box.
Step by step
- Use a line laser to mark the bottom edge of the cornice on the wall.
- Apply aluminium tape to the inside of the cornice.
- Cut the corners at 45°. Tape over the joints on the inside with aluminium tape so that light can't get through there either.
- Apply mounting adhesive (Fix Pro or Fix Max) to the side of the cornice that sits against the wall. A light cornice is fixed to the wall only, and the top edge stays free.
- Apply Fix Extra joint adhesive to the whole cut face at each joint.
- Press the cornice onto the line and support it until the adhesive grabs.
- Don't wipe away the adhesive that squeezes out of the joints straight away. Let it set for about an hour, then remove it carefully. If you wipe it off immediately, a thin gap can be left in the joint and light will shine through it.
- Leave the adhesive to dry for at least 24 hours, then fill and paint the outside of the cornice.
- Fit the LED strip into the cornice and have an electrician connect it.
Painting
Paint the outside of the cornice with a water-based acrylic paint in two thin coats, just like an ordinary cornice. The inside with the aluminium tape isn't painted.
You'll find light cornices, adhesives and aluminium tape in the LED Cornices and Adhesive/Accessories sections of our online shop.